well, maybe not so strange….
Well sony users, I am still tracking down my dialup problem (no luck yet) but I did find a really cool diangnostic /benckmarking took in the process, SiSoftware Sandra. Runs lots of tests and does a performance tuning diagnostic that found a few areas of improvement for me…and below is a list of 3 that baffled me and I was wondering if anyone here could decifer them and tell us if it’s a problem or not. I suspect not, but as I just ordered the 512 mem upgrade I’m curious….
From Sandra:
Tip T2545 - Large memory modules (256MB or greater) should be Registered/Buffered, especially if more than 2 are installed on the same channel. This improves signal quality by reducing the load on the chipset channel. While these modules add an extra clock delay due to the on-board buffers (thus CL2 effectively becomes CL3), the stability will be worth it. Server chipsets with many memory slots generally require Registered memory.
Fix: If you plan on adding more memory, consider replacing the modules with Registered/Buffered modules. Do note that you cannot mix Unbuffered and Registered/Buffered modules on the same channel, but you may be able to if the chipset has multiple memory channels.
—————————————
Tip T2546 - Large memory modules (512 or greater) should be ECC/Parity. Since the probability that a bit will be corrupt is the same or increases with module density, the bigger the module, the bigger the overall probability that you will get one or more corrupted bits. While these modules add an extra delay on partial writes (e.g. less than data width) as parity for the whole line must be re-calculated, the stability will be worth it.
Fix: If you plan on adding more memory, consider replacing the modules with ECC/Parity modules. Do note that running plain and ECC/Parity modules will turn off ECC/Parity for the whole memory array.
———————————-
Notice N224 - SMBIOS/DMI information may be inaccurate. This information is reported verbatim and cannot be checked by Sandra. While brand-name companies set this information most generic manufacturers use generic data that is meaningless. This issue generates more technical support queries than all other issues combined.
Fix: If the information is not correct, check for a BIOS update (clear DMI pool) or fix any errors using the DMICFG tool provided with the board. Alternatively, disable Sandra’s DMI/SMBIOS reporting from module Options
